Mesh / Auto Bed Leveling
chriskimbr last edited by
Steps ive taken:
- Did Home all
- Did Z Offset in center, with piece of paper. Set Z value in G31 in config.g
- Did Maually leveled bed with screws. Moved nozzle to each screw location and did G30-S1 and with paper adjust screw to have little resistence.
- Did Auto Bed Compensation (Auto Leveling) with settings in pic.
Please advise. Is this pictorial of my autolevel a problem?
What should i do?
That picture suggests that your manual adjustment of the bed levelling screws didn't work very well. You might like to try this method https://duet3d.dozuki.com/Wiki/Using_the_manual_bed_levelling_assistant.