@Stephen6309 actually after changing that it homes correctly but now thinks that its actually in the rear of Y when its at home so it tries to move the print head forward. +Y is moving forward not backward but everything else is working fine.

Ahh crap i was using Y2 in my M574 command. Changed it to Y1 and now its working.

This might be a repost or just a dumb question but ive racked my brain.

I have an Ender 4 (HBot) and when i home the system everything works properly.

The one odd thing is when its homed it things the front left corner of the printer is X0 and Y220.

On the old Printer it was X0 and Y0.

How do i remedy this?

I want the printer to think of the front left corner is 0 for both X and Y

If it's my fault it's my fault though. You guys know way more about the board than I do.

Is there an estimated repair cost to fix the board if so? I'm guessing components have to be replaced etc.

@dc42 not that I know of. I tried to be as careful as possible when dealing with the board. To expensive for me to risk being an idiot lol. I have no bed level sensor.

I haven't actually powered on the board from 24v power yet. I had to re terminate every connector on my printer with the new connections and I needed a crimper to do it so I got my board on the 15th. Then had to order the crimper which I got early this week. I crimped all the connections and used a multi meter to make sure it all looked good connection wise then I connected the board to my PC to get the wifi working and that's where we're at.

I had the board on a wooden table where it shouldn't have conducted between pins on the underside and I'm pretty sure there wasn't anything under it (wire scraps etc)

@elmoret @dc42 so what is my path forward for getting a replacement board? I'm very eager to get my printer up and running

@dc42 Removed the SD card and powered the board back on. let it run for a few minutes and the wireless gets hot but the main processor is fine, feels almost room temp.

EDIT: U2 and U11 both are the same temp as the processor aka not warm.

if the SD card is in the unit it heats up almost immediately.

Ejected SD card and powered it back on. Still no movement in device manager.

SD card slot does not appear to be heating up now. Its cool to the touch

Just verified with my finger. The SD card slot is extremely hot. i dont have a way to check the temp but its hot enough that one second on it feels like its going to leave a burn on my finger.