Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. FunBogMan
    • Profile
    • Following 0
    • Followers 0
    • Topics 1
    • Posts 5
    • Best 0
    • Controversial 0
    • Groups 0

    FunBogMan

    @FunBogMan

    0
    Reputation
    1
    Profile views
    5
    Posts
    0
    Followers
    0
    Following
    Joined Last Online

    FunBogMan Unfollow Follow

    Latest posts made by FunBogMan

    • RE: Supporting multiple configurations on a single Duet

      Like that idea alot. At the moment I use a set of different SD cards with different configurations on, eg. 1) Small table- Bowden. 2) Large table-Bowden and 3) Small table-Direct. The trick is to remember what changes you make. Often use a text editor where file comparisons can be highlighted. It works with care but have still made ommissions due to last minute changes. By the way the printer is home made and is constantly being modified.

      Just an idea but how about a programmable set of buttons on a bootup menu to select which config to use?

      posted in Firmware wishlist
      FunBogManundefined
      FunBogMan
    • RE: 3D Printing Industry Awards 2018 nominations - just 1 day left!

      Done.

      posted in General Discussion
      FunBogManundefined
      FunBogMan
    • RE: 2 Extruders only 1 steps

      Excellent, thanks for that.

      posted in General Discussion
      FunBogManundefined
      FunBogMan
    • 2 Extruders only 1 steps

      Hi All
      I am experimenting with a geared extruder which has been calibrated to get the step value right. However my second extruder is non geared and requires a completely different step value. Can the different values both be put into config.g, can only see a value for one E?
      Thanks for any assistance.

      posted in General Discussion
      FunBogManundefined
      FunBogMan
    • RE: Want to paint underside of my PEI for IR sensor, any non-baked finish?

      I have a 450mm x 350mm PEI covered bed that has been sprayed on the underside with Matt black fast drying paint. Didn't fancy risking the oven bake method as I get too many burnt offerings from the oven already. The paint I used was from a well known automotive brand and required 24hrs of drying to harden. Being skeptical of the adhesion properties I subjected the painted side to the good old masking tape rip off test and all was good. The PEI is in 0.8mm thick by 10" square sections laid out in a staggered pattern on 3M 468MP adhesive sheets. The sheets were glossy and gave me a few problems with reflectivity and David's excellent IR sensor. A few failed prints later I read about 'scuffing' the surface so got hold of a 3M Superfine abrasive pad and haven't looked back since. PEI has been a great surface for a range of filaments with a few more yet to try.
      Apologies for a long 1st post but this controller and the support given on this forum is absolutely awesome.

      posted in General Discussion
      FunBogManundefined
      FunBogMan