@dc42 okay so the only way i got the lcd and ip to show up was using there exact files from above, so i should keep the exact files and try connecting through the Ethernet? It has only been showing up as IP 0.0.0.0 so maybe i can try another port... or another router? i really appreciate the help, its 930pm here so i will have another go in the morning.

yeah i have, but when i copy the files it generates to the sd card, everything stops working, lcd included

0_1559457587265_config.g

@paulhew also this is the base files i have tried to use https://github.com/PrintM3D/Crane

@paulhew

; Configuration file for Duet Maestro (firmware version 2.02RC2 or newer)
; executed by the firmware on start-up
; Created by PrintM3D
; For Crane Quad
;
; startup!

M98 Pgeneral.g ; Call General Configuration Module
M98 Pnetwork.g ; Call Network Module
M98 Pmotion.g ; Call Kinematics/Motor Module
M98 Pthermal.g ; Call Heater/Fan/Sensing Module
M98 Ptools.g ; Call Toolhead Module

; Call QC start up
;M98 Pqc.g
;M98 Pproduction.g

i will go grab the sd card now to get the files. i cannot communicate with it at all atm.

Ok, so i already had a cr-10s5 (500x500x500) and have been printing projects on it successfully. I then learnt of colour printing with the quad fusion head from M3D and thought it looked amazing. I purchased the printer head, psu, lcd and duet 2 maestro board directly from M3D and have now spent over 2 months trying to get it to work with very little success. Everything is wired to the maestro board as shown on the M3D site but its the software i'm sure of it. i can move stepper motors and the bed and the screen works (this all from an email from M3D, but there is little to no support for this and M3D keep brushing me off. I specifically purchased the exact setup they are using on their videos thinking it will be a breeze but nothing i do seems to work ( also the filament doesn't even want to load... i think) and i cannot get the Ethernet to work or cura to communicate even tho it shows up in device manager. Does anyone out there use the same setup? I am hoping for the SD card contents for this setup, im even willing to pay someone at this stage to set it up because it is driving me crazy spending this much on this setup and not being able to do anything about it.

Duet Maestro 2
Rep rap LCD
M3d quad fusion head
24v PSU
Cr-10s5 (500500500)

Any help would be appreciated.