@jay_s_uk
Champion...thank you
Best posts made by Kiwi3D
Latest posts made by Kiwi3D
-
RE: BL Touch . CR Touch
Did another series of tests, test and results below. These only confuse me more
1.Retested CR Touch on Duet 2 Wifi
**All probing homing and manual control of probe performed perfect
2. Created a new loom and configured to use CR Touch with "io4" directly on the 6HC.
**Same results. On startup the CR Touch just flashes red. When DWC loads up, Probe is slowing 1000 REDPower to CR_Touch from both "121.io0 is 5.2V", from 6HC "io4"
; Probes
M280 P0 S1000
M950 S0 C"121.io0.out" ; 121 is my toolboard CAN ID
M558 P9 C"121.io0.in" H5 F120 T6000 -
RE: BL Touch . CR Touch
This is the 1LC End
This is the CR Touch END
This cable runs both of the BL Touch, but wont run the CR
I cannot fathom this out at all
-
RE: BL Touch . CR Touch
Hi, yes...fully checked that out. I definitely have the common wiring colors. Wiring is perfect.
The CR Touch is flashing red straight away when I turn the printer on. I can replace with one of two BL Touches and the work perfect
It's bizarre
Ray
-
BL Touch . CR Touch
Just replacing my BL Touch with a good, known working CR Touch
The CR Touch works fine on the Duet 2 Wi-Fi....however, migrating it to my 6HC / 1LC to replace a BL Touch. The CR Touch just flashes RED on boot and DWC shows a RED 1000
Cabling is sound, tested and good and as it should be, as working with a BL Touch. The wiring on the CR Touch is colored as expected , with the RED and WHITE being tested as common ground.
Tested by swapping the Blue and Yellow (In / Out) and no change
Thoughts?
Cheers
Ray
-
Z Drop on X Home (CoreXZ)
Guys,
Having a small issue that Z is dropping a couple of mm during X Homing
Any ideas would be helpful please
; homex.g
;echo "home the X axis"
M400 ; make sure everything has stopped before we make changes
G91 ; relative positioning
M915 P0:5 S5 H200 F0 R0 ; Configure Stall Detection
M906 X300 Z300 ; set homing motor current
G1 F5000
G1 H1 X-254 ; Home X-Axis independently
;M906 X1000 Z1000 ; set homing motor current
;M915 P0:5 S35 H500 F0 R1 ; Configure Stall Detection
M400 ; make sure everything has stopped before we make changes
G90 ; absolute positioning
G1 F7000 X125 -
RE: Core XY - pulling my hair our.
G'day ...yes...that part is perfect
Thought the below video might explain my issue better