@dc42 The topic seems to have slowed down. I was wondering if you have a recommendation for next steps. Is there something else to try or should I file a warranty claim?

@dc42 Here is another picture that may be higher quality but it is still difficult to see the mark on U3

@bearer I saw that, it is more visable at certian angles but it is hard to tell in those pictures. I took them on my phone but my camera is charging now so I will try to get a better angle after it is done.

Here is a picture of the entire board as well as one close in on U3

@dc42 Yes, I plugged it in and some parts got hot very quickly. Specifically something labeled U3 which got very hot after only a few minutes.

Thank you @bearer I have tried just about everything on there with no luck.

Hi everyone, I am currently having a hard time connecting to my new Duet Wifi 2 over usb or DWC. Initially it connected normally and I was able to run some tests and upload new firmware. Later when I tried to connect, it was as if I had the wrong IP address, so I tried to connect via USB to see if it had changed. When I plugged the board in, nothing shows up in the device manager and I am unable to connect. Also, Here is a picture of the lights that come on when connected via USB. It is hard to tell but the grean light does come on, but it is not bright and does flicker. Any help is appreciated.