@dc42 And what about the 10 pin cable ? how long can it be ? and does using it also effect the pt100 daughter board ?

hi, need help with what ribbon cable lengths will be ok to use on the e3d tool changer, i mean the 10 pin one, read 400mm is max out, but for the tool hcnager i reckon i need 600 or 700mm so can that long a cable be used ?, also is it ok to use a pt100 board with a longer ribbon cable ? and for the normal cables i read somewhere u cant use the sd card slot if u use them on the panel due, however do the other functions work ? wasn't mentioned, any clarity on that,

@zapta my guess is sometimes you can get faulty boards or drivers, electronics are after all not a 100% all the time, or it could be a wiring thing from the @E3D ppl, anyways i will have to investigate this, and hopefully i get a replacement

Good news is that after adding the R-1 the alarm went away, now i must inspect all the wires to be very sure before plugging them in :), but hope i get a replacement

@bearer i think i should have but generally i never had issues with their stuff, so was relaxed on the checking part, but i guess need to check even if its from the most dependable companies

@bearer ok will try this to see if error goes

@bearer the line there says M569 P3 S0, so i need to add like this M569 P3 S0 -R1 ?

@bearer strangely the wiring came from E3D so i am perplexed how they would have messed it up

@bearer i didnt try that as yet but, i can try that and see , firstly i think want the alarm gone, cause those keep coming

@bearer where can i M569 this, in the config.g , just asking cause i am new to the duet, but have expeirence with other printer boards, also i tried to swap the ports from 3/4/5/6 to 7/4/5/6 that didnt get the alarm silent as well