@alankilian said in Duet2/Ethernet Update from 2.05 to 3.2 went perfectly.:

B57560G104F

Thank you very much @alankilian . This is a huge help.
Your answer actually highlights one of my difficulties...
The NTC thermistor you provided has Beta values indicated on its product page of (4066 K, 4036 K, 4085 K), and the datasheet has them as (4072, 4036, 4092) and the product page values aren't even represented in the datasheet.
M308 commands in your config.g set the thermistor Beta value as 4385. I am not saying that it isn't correct, but I don't yet know how to determine how to setup these thermistors for the Duet firmware. BTW - I am currently using v3.2.2.
The other value I don't get is the T100000 - shouldn't that be T104000?
How did you determine the C value for the bed thermistor?
Thank you again, Karl

@alankilian - did you come up with a working set of duet2 files for use with the SE300 ?
SeeMeCNC is REFUSING to tell me what the specs are for the SE300 so I can setup the e0temp and e0heat.
I can't figure out what type of temperature sensor it has or its Beta value or the heater parameters either. Very frustrating considering I supported them when they started up, and just paid for the SE300 but the most they would tell me is "change the parameters in config.g".