Thx for this idea. I turned on ac and measured on the 10 pin expansion pins on the duex. i get 3.3V like it should be.
Its nearly impossible to get the 50 pin ribbon cable here in switzerland or even in the eu. Dont wanna buy a duex extra only for the ribbon cable.
Hi,
now i got time to do some tests. I think the duex is not broken. when i measure between black vin on the duex and the motor pins i have about 7v. also the bl touch is working. What could be the problem ?
BTW i fixes the problem with the paneldue 
thx for this.
Thanks for your reply.
I can measure it and will report back.
The 40pin cable to connect the duetwifi to the duex5.
i tried to connect it via the 4 pin cable and got the same effect. The 10 pin cable is about 15-20 cm long.
Greetings
Hello
Ive got a railcore and it could be that i grilled my duex5. I connected it reversed polarity and now its not booting.
Things ive checked:
M115 in dwc doesnt show a duex5 is connected.
Tried it with 5v to test, no movements.
Corrected the polarity
Checked the fuses. They are all good.
I ordered a 40pin cable to test it but need to wait until it arrives.
Anyone had a same situation or has an idea what i could do next?
Secound topic:
The paneldue7i that i got isnt connecting to the machine. I haave the newest firmware and in the config.g its enabled. Connected it with a 10 pin on the correct slot ob the duetwifi. Baudrate is equal.
In the right top spot it only shows connecting but never change to idle.
What can i do here ?
Greetings and have a good day.
Chris
@Danal
Oioioi thats quite complex.
I run my palette 2 on several printer via octoprint. Thats good but my point as you noticed correctly was to use the benefits of dwc with this. It would be a bit of waste to have a great board and then block it because you need to be forced to use octoprint.
Maybe there is a way in the future:)
Hi,
Im building a Railcore at the moment and i know that there is no plugin available for palette 2 at the moment.
Is there a way to use it in connected mode or are there plannings to release a plugin ?
Thanks and have a good time.
Chris