Posts made by ameigh710

Hello, I have done a little bit if research but can't seem to find the answer I need.
In short I would like to know if this is normal, if it is I know I need to research firmware, if not I need to figure out wiring/if I have an issue with my board.
When I pull thermistor 0 from my board it reads 100k ohms.
When I replace in the board it reads 3mohms ( or was it 300m ohms).
I'm sure I'm reading something in the board, but is this normal?
Firmware is setup for standard e3d therm, t100000 b4725
C I tried values from configuration of e3d and Honeywell.
In DWC it actually shows error