Posts made by AP1

I think I read the "how to connect z probe" part right, but I do better with schematics than words.

I wrecked my last board thinking that I'm smarter than I really am. Trying not to make the same mistake this time.

PNP NO inductive sensor.

Ok I have the z probe wired. Without triggering the sensor im seeing 0v and when I trigger the sensor with a piece of metal im seeing 9.28v. Is this right? Using 10.15kohm and 32.3k ohm as measured resistors.

To be clear i get 9.28v between gnd and signal and 2.9v between signal and hot. With a 12V power source.

I just got my duet wifi in the mail! I'm pretty excited to get it hooked up. I do have a few questions though.

I'm pretty sure I do not have a z end stop. I have a z probe (inductive). On the printrboard it is connected to the z endstop plug (3 wire), but with the duet wifi I have a the choice of 3 wire z endstop or a 4 wire z probe? How do I hook it up/configure it?

What is the normal plug for the primary hotend?

I am familiar with marlin mostly. I am also very new to 3d printing. I do understand g and m code.

Coming from a printrboard I'm used to a convoluted horrible method of flashing the firmware for a simple configuration change. I somehow bricked my board (i got carried away with the icsp) It is my understanding that the duet takes configuration from a text file