@jay_s_uk
Ok I have been able to upload the firmware. I turned on the bed heat and it works !!
Thank you again for your time and kindness.
@jay_s_uk
Ok I have been able to upload the firmware. I turned on the bed heat and it works !!
Thank you again for your time and kindness.
@jay_s_uk
Ok I have been able to upload the firmware. I turned on the bed heat and it works !!
Thank you again for your time and kindness.
@jay_s_uk
When I try to upload the all zip file I got this after cliking yes
M997 S0:1
Error: M997: in application programming binary " Duet2 combined IAP.bin" not found
@jay_s_uk
I have done nothing yet . I just don't know how to upload this file on the board. My board is duet 3D 2 wifi
@jay_s_uk
How can I upload "Duet2_SDiap32_WiFiEth.bin" ?
@jay_s_uk
When I enter M115 I got a version 3.1.1 but when I check the version of the firmware I configured on reprapfirmware config tool it is the 3.3.0
@jay_s_uk My version of the firmware is much recent
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.1.1 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2020-05-19b2<LF>ok<LF>Auto tune heater 0 completed in 153 sec<LF>Use M307 H0 to see the result, or M500 to save the result in config-override.g<LF>
@jay_s_uk
I enter the Gcode M303 H0 S60. The temperature increased to 60 ° C and then decreased to room temperature.
Then I activated the bed heating to 60 °C to run a test and it worked.
So thank you a lot.
I enter the Gcode M303 to see if it was tuned properly and I got this as an answer.
M303
Heater 0 tuning failed<LF>ok<LF>
Will it be a problem in the futur ?
Thank you again
@jay_s_uk
This is what I got
M303
No heater has been tuned yet<LF>ok<LF>
Hi everyone
I got troube configuring my heating bed on my printer. When I try to warm up the bed the temperature reaches 40 ° C ( more or less ) and this message appears " Error: Heater 0 fault: temperature rising much more slowly than the expected 1,6°C/sec"
My bed is a keenovo 300 mm x 300 mm. 750 Watt 220 volt connected to a relay SSR-25DA.
The sensors seems to work correctly ( it detects room temperature ).
Thanks for your help.