Topics created by Arisoy

@fcwilt Ok i think i'll maybe do the Z home like this too.

Thanks you all for your patience and for your help 🙂 🙂

@arisoy Glad you got it sorted. Maybe you did the calculation for 0.9 degree steppers? - They have 400 full steps per revolution which would be 50 full steps per mm, so 800 would be correct for a 0.9 degree motor.

@arisoy I have tested that file under RRF 3.4beta7. If I have the drivers in spreadCycle mode, it works. However, if I have them in stealthChop mode and I start the file without doing the correct stealthChop tuning procedure first, then the drivers provide excessive current to the motors. So I suspect that the issue was caused by lack of stealthChop tuning in the homing files.