I just bumped my base printing speed to 100mm/s (from 5) and it seems to be working out more or less

@dc42, thanks for response. I have duet 0.8.5, and seems like I do need H parameter. But it is definitely being ignored when I set it. Could it be that my firmware (1.24 (2019-06-13b2)) has it disabled (looks like it's ifdefed in the code depending on configuration?).

I just bumped my base printing speed to 100mm/s (from 5) and it seems to be working out more or less

@DocTrucker said in Very slow ABS extrusion speed (5mm/s):

A linear filament speed of 5mm/sec equates to about 12mm3/sec which would be over 100mm/sec print speed with 0.48mm track width and 0.25mm layer height.

Hmm, indeed, thanks for pointing this out!
I incorrectly took 5mm/s and set it as my base printing speed, while I should have gone with something like 100mm/sec.

@Veti, I checked my thermistor setting and it was a bit off, but not really.
I'm having troubles with M305 command though. Seems like it requires 'R4700' although documentation says it doesn't. Also it seems to ignore the H setting that adjusts the temperature. I suppose I should start another thread about that.

Thanks, I will double-check that (because I haven't).

But also, I forgot to mention that I've installed nozzleX, and perhaps that is the reason the heat is not reaching the plastic as well. I seem to remember someone mentioning issues with thermal conductivity of the nozzle.

It seems that I can't extrude ABS faster than 5mm/s. If I increase the speed, the extruder starts skipping steps, and even if not, it looks like plastic is not melted enough when it comes out.

I think I have 40w 12v e3d heater cartridge and e3d v6 hotend. 0.4mm nozzle. BondTech extruder. Duet 0.8.5 with latest firmware.
I have ran heater calibration.
I increased temperature to 250c, and it did not seem to help.

Is there something I'm missing?
What extrusion speed should I expect with my setup?

I did not see people complaining about low extrusion speeds. And I think I even printed ABS myself faster than that before (but I have switched hotend and extruder since then, and it was a while ago).

Any advice is really appreciated!