That's too bad.

I removed the SD Card and still get no response. The wifi module continues to heat up.

I connected jumpers to the erase pins and the board would get recognized by my computer but as "Unknown USB Device (Device descriptor request failed)"

Thanks for your advice, I suppose I'll hope it's still under warranty.

Hey guys,

It was working yesterday, but this morning it is having issues.

I can't connect through the web interface, or YAT.

When I plug it into my windows computer:
There's no blue lights coming from the wifi module.
The Diag red light is on, and stays on
The red light between the reset and USB power is on
the green light for 3.3 is on, and the red for 3v is on.

Within a minute, the wifi module gets hot, eventually to the point where it's uncomfortable to even touch.

Any ideas?