Hi,I'm starting to test gcode out of Fusion, and I seem to have an issue with I and J arc factors.
Saw on the duet wiki that those two are not supported.
Is there any release after 3.3 that tackles this, or any known fix?
For now I'm using the Workbee postproc, just looked at this one https://github.com/BruceRoyce/UltimateRepRapPost , but Fusion says it's invalid..
Thks.

@budspencer I did this yesterday and didn't work, this it went perfect, thanks mate!

@stephen6309
Ok this confirms the obvious fact that all my tentatives can't be successful until I can have firmware flashed. But how can I do this I have no way to discuss with the board?? it looks like the chicken and egg problem..

Hi guys, new to the forum, in general I try to debugg myself alone using net ressources but I'm close to nervous breakdown with this board.
Issue is that I can't get this thing to communicate by any mean.
So far I've tried, USB and yat terminal, after installing duet drivers, it appears as Bossa port in devmgr, connects via Yat, but commands have no effect.
Formatted SD, pushed a fresh config and tried to connect via DWC, nothing.
Panel Due is also connecting forever.
Any ideas of where to look for before buying an original Duet board, or someting else?
Tanks for your help.