@cadsys Ok I got it working by moving the control wire to physical pin 21 as shown on ANTCLABS's website. I finally found the correct pinouts here: https://reprap.org/wiki/Duet_pinout for the 0.6 board. It shows heater 3 on pin 21. Deploy and retract now working via M280 commands.
Best posts made by cadsys
-
RE: Duet 0.6 and BLTouchposted in Duet Hardware and wiring
-
RE: Duet 0.6 and BLTouchposted in Duet Hardware and wiring
I figure I would just post this for any other idiots like myself trying to hookup the BLTouch to the Duet v0.6. Strangely enough it works without hooking up the Black Ground wire as shown on ANTCLABS's website.
