Just found this guide, It should clear up many questions: https://forum.prusaprinters.org/wp-content/uploads/wpforo/default_attachments/1596858738-ZMK3s-Duet2W.pdf
citybird
@citybird
rebuilding 3 printers, one at a time.
(the plan)
Prusa Bear clone - converting to Duet2WiFi (Probably the E3D Herma and fans too)
Zonestar - converting to 12v, Linear Rail, Bear frame, E3D Hemera, Duet2WiFi (Gonna upgrade that bed too)
Ender 3 v2 - upgrading to dual Z, considering the upgrade to the Duet2WiFi if the Creality 4.2.7 board fails.
Best posts made by citybird
-
RE: Duet 2 WiFi - connecting 3 wire 5v fans [solved]posted in Duet Hardware and wiring
Latest posts made by citybird
-
RE: Duet 2 WiFi - connecting 3 wire 5v fans [solved]posted in Duet Hardware and wiring
Just found this guide, It should clear up many questions: https://forum.prusaprinters.org/wp-content/uploads/wpforo/default_attachments/1596858738-ZMK3s-Duet2W.pdf
-
RE: Duet 2 WiFi - connecting 3 wire 5v fans [solved]posted in Duet Hardware and wiring
@Veti said in Duet 2 WiFi - connecting 3 wire 5v fans:
Or you can leave it not connected.
Thanks Veti, I wasn't sure if these instructions were for 4 wire fans only and I missed that last sentence completely.
-
Duet 2 WiFi - connecting 3 wire 5v fans [solved]posted in Duet Hardware and wiring
Hi, what is the recommendation for using 3 wire fans with the Duet 2 WiFi board?
I have a Sunon Maglev MF40100v2-1000C-G99 fan that takes DC5volts and 0.65wats. It has 3 wires.