Thanks for the hand dc42, I didn't succeeded with P5 but I managed to get it working using P1 (inverted with I1). So I'm now using AD12 for the probe signal and the 3.3V power on the sensor port. All the best!
Posts made by Cuteberry
-
RE: Change Z-probe E0 pinposted in Duet Hardware and wiring
-
RE: Change Z-probe E0 pinposted in Duet Hardware and wiring
Good point! I tried but I realised soon after that this sensor is normally open, so I get 0V when triggered whereas "the input must be active high when triggered" in mode 5. Any chance to invert it (as mode 3 for mode 1)?
-
Change Z-probe E0 pinposted in Duet Hardware and wiring
Hi! Yet another Duet lover here!
I've some projects involving E0, E1 and E2 endstops pins in a near future and my Z-probe is currently using E0… It's a capacitive NPN sensor and I'd like to use E3 rather than E0 for example.
Do you know how to deal with it? I can proceed to minor firmware modification, but I'm a bit lost currently to find where I could tune this.
Thanks a lot!
Setup:
- Duet 0.8.5
- PanelDue 4.7
- MakerGear II custom