@Danal Those steppers come pre-wired. They don't plug in with JST on the motor side.
Best posts made by Deneteus
Latest posts made by Deneteus
RE: All Drivers give me disconnected reported by driver
RE: Duet2 WiFi Design Files?
I was under the impression that the Duet WiFi and the Duet 2 WiFi were 2 seperate products with different features. For example the documentation says that the Duet2 Wifi can support 5v endstops. The Duet can't but that info was buried in the page rather than being on its own dedicated Duet 2 FAQ. Also when you look at the layout page thats supposed to list all the connectors it makes no differentiation between the products.
After reading your post I found some clarification here:
This should be stated clearly in the documentation. If something is a new series then it shouldn't have the same name.
I really don't want to print something just to find out its got the wrong layout because they didn't keep the newer boards listed with the 'Duet 2' moniker.
Duet2 WiFi Design Files?
I haven't been able to find any Duet2 WiFi specific cases or design files only the Duet 2 Maestro.
If you search for 'Duet2' or 'Duet 2' you get nothing but Duet cases on Thingiverse.
I want to design my own but I haven't seen any design drawings or cad files in the documentation.
I did manage to find the PCB on Github but I was looking for Fusion 360 files.
The fact that the Duet 2 specific board info isn't separated in the documentation doesn't make any sense. It should be setup just like the Prusa Mk2 and Mk3 info where the documentation is specific to each board.
Thanks in advance!
RE: Repetier > RepRapFirmware conversion| Hatchbox Alpha
Repetier > RepRapFirmware conversion| Hatchbox Alpha
I purchased two Duet2 WIfi boards from Printed Solid to replace the boards in a couple Hatchbox Alpha printers.
Is there an easy way to convert a Repetier config into a Duet RepRapFirmware Configuration?
I exported my default configuration settings via Repetier Server and I have a copy of their firmware config that I got from their support for reference. I am aware of the RepRapFirmware Configurator and Delta Calibration Wiki.
I just wanted to check to see if there is an easier way before I manually enter all the settings since I have 2 printers to setup.