@Alex-cr It does not do the self test of deploying and retracting. I am also realizing this is the wrong forum sorry. This has just been a nightmare and I'm looking for help from all sides
Posts made by DerivedLimited
-
RE: BLTouch Probe Not Deploying.posted in 3D Printing General Chat
-
BLTouch Probe Not Deploying.posted in 3D Printing General Chat
Hello,
I have an Ender 3 V2 with BLTouch from ANTCLabs. It was set up and printing fine for a while, then I changed the nozzle, attempting an auto home. When I did that the print plate went farther back then it should have and started crashing against the rear. I turned the printer off, powered it back on, and my BLtouch has not worked since.
I cannot get the printer to move down on the Z axis. I have tried reflashing the firmware. When my printer starts up the probe for the BLTouch does not deploy anymore. When I run an m119 through pronterface it shows the Z probe as triggered when its not and open when it is triggered.
I cannot find a way to reverse this. I have a video of my machine starting up that I will post below
It will also give me this error [ERROR] Error:!! STOP called because of BLTouch error - restart with M999