THANKYOU for your responses I will try your suggestions

Thx Guys I did find the global section but something in one of the configs is telling it to move at that speed start of the print.

These manufacturers like to show off so they put these super fast movements when its not needed.

M92 X160 Y160 Z160
M906 X1100 Y1100 Z1100 E1100 I40
M201 X4000 Y4000 Z4000 E4000
M204 P1000 T4000
M203 X18000 Y18000 Z18000 E18000
M566 X1000 Y1000 Z1000 E1200
M665 L400.290 R228.5 H410 B130 X0 Y0 Z0

Start of print after homing the extruder head on my Delta is coming down way too fast at the start of the print. This printer purchased already assembled with a duet 2 ethernet. First time duet user.

I can read the config files on the web interface I'm just not sure which F speed I need to adjust , I thought it was the G1 command. Usually these settings are in the slicer but it just has the g28 homing command. Simplify 3D

Thanks !!