Posts made by Dr. NoNo

On a side note, customer support at Fusion3 was clueless.

Thanks again,
David

Very cool, you've saved me a great deal of pain.

This was at the bottom of the config file. I just commented out everything below "Play startup beep"

; Play startup beep
;G4 P1000
;G4 P50
;M300 S3000 P250
;G4 P250
;G4 P50
;M300 S3000 P250
;G4 P350
;G4 P50

Thanks,
David

Greetings,

I'm new to the Duet (0.8.5) in a Fusion3 400s. When I connect to the printer from my Mac, the computer makes a very loud and annoying beep. I have not tried in on a PC, but it's the same using Safari or Chrome. Can this be turned off? Is it part of the firmware?

It's enough to cause a mild mannered engineer to "PC Load Letter" on this thing, or at least consider switching to OctoPrint.

Thanks,
David