@jay_s_uk Quick question - I am not connected to the board (since wifi is not stable). Is there a way to access the DWC other than wifi? I don't think usb supports it... thank you

@jay_s_uk Thanks so much!

@jay_s_uk Thank you - is there a non-destructive way so that I keep my settings and configs that were specific to this printer?

Brand new Duet 3D w wifi was installed to upgrade my Rostock Max 3D printer. Used several times without any issues. After a couple months of no use I just powered it back on and the screen on the Rostock keeps reporting "error: wifi module reported: auto reconnect succeeded"

Literally nothing changed since last use. It's in a temp controlled environment. no humidity etc. I believe that I am using v3.4.4

Thank you in advance for any help... super, super frustrated that the brand new board is acting up.