It is a new core xy build I selected the bltouch when doing config.g before I loaded it I will however post a pic of the wiring and the config.g and home settings shortly as only just got home

I have fitted the latest v3 bltouch on my new build and on start up It does the self test then stops with pin up and led red but the pin does not deploy if say i home axis
Any ideas would be appreciated

I wired these myself there are all wired the same way and connections are good although would I need to up the voltage as using the 2 z ports

@dc42 thanks for your reply
I can confirm the x and y do move after I over wrote the home all m564 s0 h0 but the z axis dont move And makes shuddering noise

I am having issue where the motors judder all except 2x extruders at this point I cant tell if it is the config for motors or the endstops on the z I have a bltouch but I am more bothered about getting x and y working first then worry about z later.my x and y endstops are triggering when I press them both lights on the end stop and board light up they are the 3 wire mechanical switches any advice on where to start would be appreciated. Thanks in advance