Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. EEngineer
    3. Best
    • Profile
    • Following 0
    • Followers 0
    • Topics 1
    • Posts 9
    • Best 2
    • Controversial 0
    • Groups 0

    Best posts made by EEngineer

    • RE: Z offset resets on every print or Homing and start gcode asking

      @fcwilt
      I think I read somewhere that I should use relative extrusion. is it right? Then I should include in the start g-code

      posted in Duet Hardware and wiring
      EEngineerundefined
      EEngineer
    • RE: Z offset resets on every print or Homing and start gcode asking

      @fcwilt

      Now I set my Z Trigger height in G31 according to this:
      https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe#Section_Calibrate_the_Z_probe_trigger_height

      After that my print start has began on the right Z height.. Thanks for the advices. As I see now, that was my problem..

      My other question is, what do you think, what should I include in my start or maybe end g-code on an idex.
      Is there something special for RRF that I should include in these?

      posted in Duet Hardware and wiring
      EEngineerundefined
      EEngineer