Posts made by Eldee

@fcwilt
That is how I was testing it. Thanks.
I see. It only shows the state change not the static condition. Now on to bed level. One of these days I will be able to squirt some plastic.

@eldee The simple stuff will kill you. I was checking the state of the GND-In pins off the BLT on the Duet2 and found I had them reversedon the board. That part is happy now. The state of the Z on the control (Status/Sensors/Zprobe) still shows 0 though in either state. I thought it showed a state change from low to high ( a thousand ish) on the web control between deploy and retract. AM I looking at the wrong field for this?
I am running DWC3.4.1 if it makes a difference.

I am finishing up a Railcore ZLT. I have everything working so far except the BLT. It is on a Duex5 on PWM1. Deploy and retract work but the position is not registered. It stays at 0. The home routine works fine. BLT deploys and Z heads up, actuates the BLT and Z does not stop. Is there an obvious code mistake here? Thanks in advance for responding.

; Endstops
M574 X1 S1 P"xstop"                            ; configure switch-type (e.g. microswitch) endstop for low end on X via pin xstop
M574 Y1 S1 P"ystop"                            ; configure switch-type (e.g. microswitch) endstop for low end on Y via pin ystop
M574 Z1 S2                                     ; configure Z-probe endstop for low end on Z

; Z-Probe
M950 S0 C"duex.pwm1"                          ; create servo pin 0 for BLTouch
M558 P9 C"^zprobe.in" H5 F120 T6000            ; set Z probe type to bltouch and the dive height + speeds
G31 P500 X0 Y0 Z2.5                            ; set Z probe trigger value, offset and trigger height
M557 X15:215 Y15:195 S20                       ; define mesh gridcode_text