Hi
I didn't think of data being stored clientside. I must say that I dislike having persistent clientside settings. It would be a lot better to have the GUI to report what is actually going on on the printer and to be consistent to all connections.

Hi
I have recently setup a Mini Kossel from think3dprint3d.
Firmware Name: RepRapFirmware for Duet
Firmware Electronics: Duet 0.85
Firmware Version: 1.18.1 (2017-04-09)
Web Interface Version: 1.15a

When I use chrome to access the duet by it's IP address I see different machine steps to when I access the same duet by DNS name. I only really noticed when I was setting the probe by T3P3's instructions. The DNS version Z Buttons are -100, -10, -1, -.1 +.1, +1, +10 and +100. The IP version has -50, -5, -.5, -.05, +.05, +.5, +5, and +50. I can't see any othe differences but I have not checked too much.