Thanks @chrishamm

Hi all, I am Emmanuel Katto. I’m working on a project that requires multiple extruders, and I'm using a Duet 3 board. While I’ve followed the basic setup instructions, I’m finding some areas confusing.

• Can someone provide a step-by-step guide on configuring the extruder settings in the firmware?
• Are there specific parameters in the config.g file that I should focus on for dual or multi-extrusion setups?
• How do you manage retraction settings for multiple filaments, and do you have any tips for minimizing oozing issues?

I appreciate any guidance you can provide!

Thank you!
Emmanuel Katto