Hello, I am working with a delta machine and a bltouch probe.
The probe offset is X-40 from the nozzle (I set it up in my G31 X-40 Y0 Z2.32 P25).
Here http://escher3d.com/pages/wizards/wizardbed.php i can set my probe offset and the test points seems to be perfect for G32 but, is there any way to indicate my probe offset for bed meshing? (G29).
I can set only printable radius and distance from probes but not where to probe:
M557 R110 S20
so when is running G29, with the left points, bltouch is outside of the bed.
Thanks and sorry my english.

same problem, it get connected but in a few seconds connection timeout, connection reset, etc. if i do ping continually some are lost. That not happend on 1.18. Something with wifi is not as good as previous version.

thanks, I updated to 1.19, sent M588 S"*" and yes, it forgot my network settings. Then go back to 1.18 due to poor wifi signal in 1.19 and constant conection loses but again it is necessary to go to DuetWifi with my mobile and set it up for my network every time i reboot the board
Even I pressed the erase button and do Fallback procedure #3 but no luck.
Thanks for your help

thankyou for your answer, yes, I just try again by updating to 1.19 and the wifi conection is unstable. Revert back to 1.18 and conection is perfect but it doesn't remenber my wifi network and password when I reboot the printer.
Where are those settings stored? maybe is a wrong file permission?
thanks again

Hello, first sorry my poor english.
yesterday I update my duet wifi to 1.19 and i got many problems with wifi about poor signal and it loses the conection with my router. I could check many ping loses.
So I decided to rollback to 1.18 and seems to work fine with very good wifi signal and stable conection.
The problem is that every time that I reboot the duet it forget my wifi network and it is necessary to be paired again by conecting with my mobile to Wifiduet and doing the wifi setup.
Can you help me please?
Thanks in advance