Hi Duet3d forumites,
This is my first post here, the title explains my project reasonably well.
I have recently acquired my own CubePro and based on my previous experience with the things my plan is to replace the 3DSystems electronics and extruders.
I have searched this forum and I am aware that it has been done with Duet3d by others so I'm looking for a bit of advice on Duet board selection starting out.
I am a modelmaker and would really like to end up with a printer that can reliably print ABS, and if possible be capable of printing nylon.
I have gutted the existing printer, all that is left is:
A nice closed chamber with a printing frame, X and Y on linear bearings and Z on a threaded rod.
1 x Z-axis stepper.
2 x Y-axis stepper (they were wired in parallel).
1 x X-axis stepper.
Chamber heater (240v) with solid state relay (had 12v input)
24v PSU (16A - i think)
I don't have the CubePro print bed, I have spare heated ones from my Zortrax M200 and M300 which I could make use of if they are suitable.
I would appreciate any input regarding gear selection at this point to avoid ending up with unsuitable, incompatible or frustrating combinations of gear down the line.