Posts made by ginoocch

@dc42 said in SSR bed heater + Duet2 config:

Is the 15A bed heater fuse on the Duet intact?

Yes, its fine.

Switching to E02 on the duex worked great, and now I get a fun light indicator Thanks for your help!

M98:

11/30/2020, 7:08:09 PM 	M98 P"config.g"
Warning: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicted to reach 295C
Warning: Heater 2 appears to be over-powered. If left on at full power, its temperature is predicted to reach 533C
Warning: Macro file config-override.g not found

Voltimeter: Good call. This seems to be the issue. I connected appropriate probes to the heater+ and - duet ports and observe 0.15V voltage regardless of the heating state in the web panel. Not sure why there is a background voltage, but this is obviously not sufficient to trip the 4V cutoff of the SSR. Is there something in my configuration that would lead to the voltage being so low/not working? I measured the voltage directly at the connector ruling out a wiring problem. If it is a duet hardware issue, is it possible to just run the ssr off of one of the 5 extruder heaters on the duex board?

Hello!

Background: (I'm building a railcore). I'm trying to setup an SSR controlled main voltage bed heater, but I cannot get the SSR/bed heater to power on.

Board setup: Duet2Wifi+Duex-5, Firmware 3.1.1 (2020-05-19b2)

SSR setup: Output side: Mains + bed heater. Input Side:Duet Bed heater(-) connected to ssr input(-) and Duet bed heater(+) connected to input(+).

I have minimally confirmed that the SSR works (applying a 5V potential across the input side turns on an indicator light on the SSR). However, when connected to the Duet2 this indicator light never turns on (i.e. when bed heater is set to active and set temperature is elevated). This suggests to me this is probably an issue with how I have my board configured. Hopefully a typo or left out GCode! I've looked at it for hours along with others' configuration files, and can't find what I've missed. Maybe someone could take a look at my config file and see if anything stands out as wrong or has troubleshooting suggestions?

Thanks!

heater relevant config.g:

;heaters
M950 H0 C"bedheat" Q10 T0
M950 H1 C"e0heat" T1
M950 H2 C"e1heat" T2
M140 H0 ; the bed heater is heater 0

M570 S360                                  ; Print will be terminated if a heater fault is not reset within 360 minutes.
M143 H0 S150                                ; Maximum H0 (Bed) heater temperature
M143 H1 S400                               ; Maximum H1 (Extruder) heater temperature 
M143 H2 S250
M140 S0 R0                           ; Standby and initial Temp for bed as "off"

full config.g
config.g