Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order
    1. Home
    2. hairy918
    • Profile
    • Following
    • Followers
    • Topics
    • Posts
    • Best
    • Groups

    hairy918

    @hairy918

    1
    Reputation
    3
    Posts
    1
    Profile views
    0
    Followers
    0
    Following
    Joined Last Online

    hairy918 Follow

    Best posts made by hairy918

    • RE: Makerbot endstop as delta Z-probe

      @jay_s_uk: Hah! Got it! So it turns out I tried many but not all perumutations. This worked, I didn't have the ! in the M558 command before:

      ;M574 for e0stop (removed)
      M558 P5 C"!e0stop" H5 F120 T6000

      Thanks!!!

      posted in Duet Hardware and wiring
      hairy918
      hairy918

    Latest posts made by hairy918

    • RE: Makerbot endstop as delta Z-probe

      @jay_s_uk: Hah! Got it! So it turns out I tried many but not all perumutations. This worked, I didn't have the ! in the M558 command before:

      ;M574 for e0stop (removed)
      M558 P5 C"!e0stop" H5 F120 T6000

      Thanks!!!

      posted in Duet Hardware and wiring
      hairy918
      hairy918
    • RE: Makerbot endstop as delta Z-probe

      Thanks, Veti - when I remove M558, then it no longer shows up on the console as a Z-probe and the G30 command fails with "Z probe 0 not found". Putting M558 back in, a Z-Probe sensor shows up again, but registers 1000, and the G30 command fails with "Z probe already triggered".

      I should also have said at the beginning, just upgraded to firmware 3.2 using Duet 2 Wifi.

      posted in Duet Hardware and wiring
      hairy918
      hairy918
    • Makerbot endstop as delta Z-probe

      Hi, all. I'm trying to use a Makerbot 1.2 endstop as a Z-probe for a delta printer, and I cannot get it to invert properly - it keeps showing 1000 in the dashboard untriggered, 0 triggered. I've got it connected to E0, I've tried all combinations of the M574 and M558 commands:

      M574 E0 S1 P"e1stop" <both !e1stop and e1stop>
      M558 P5 C"e1stop" H10 F120 T6000 I1 <both I1 and i0>

      What am I doing wrong? I'm using the same stops for the X/Y/Z towers and they work fine, but not here. Many thanks - I'm using an inductive probe right now, but I want to switch to a glass build plate.

      posted in Duet Hardware and wiring
      hairy918
      hairy918