I recieved the W5500 today and soldered in his Place.
It was a bit tricky but the Board and the Network are alive.
Latest posts made by HarBo
RE: No 3,3Volts after mistake
The regulator has no "R" in the part number.
I have removed the Sd Card an its still no power on 3.3V
i had an Piezo orion to the Board connected when i damaged it and the Orion is broken.
had to Power the Board half an hour but could not identify a chip that is very hot.
It seem to me that i have not enough skill to repair the Board. thats to bad.
No 3,3Volts after mistake
i own a Duet Maestro, on building my printer i shortend the GND from "always on" Fan J24 with - from PWM Fan0 J25.
Now i knew it was a terrible idea.
The 3,3Volts LEd was off.
I replaced the U2 low drop reg, because i measured on the Out only 0.6 volts
but after replacing this part the 3.3 Volt rail is still dead.
can someone give me tipps to repair my Board?