I was reading through the forums, I didn't realize I could just use the 4 pin connector and not the ribbon cable to use the LCD. So I removed the ribbon cable and only attached the 4 pin connector and all is working. So this means I just can't use the sd card slot on the PanelDue.
Best posts made by hendo420
Latest posts made by hendo420
RE: Voltage drop on Duet Wifi when connecting 7" PanelDue
Voltage drop on Duet Wifi when connecting 7" PanelDue
E3D sent me over here to troubleshoot and/or get warranty replacement authorization.
With the duet 2 wifi and PanelDue connected I get a display and can access the web panel, but when I try to move motors they don't move. I checked status with m122 and the voltage is showing as 8.2v Through troubleshooting I disconnected the PanelDue and the voltage went back to 12.3v and all of the motors now work. For some reason the PanelDue is dropping the voltage from 12.3v to 8.2v which is causing the Duet to disable the motors as the voltage is too low. Is there something wrong with the PanelDue? I have checked voltage coming in with a multimeter and it shows 12v at all times.