@insertcoin said in Final calibrations for RostockMax V3.2:
Should i go ahead and put g29 in my config.g?
No. G29 will run a probing routine of the bed surface as defined by the grid setup by M557. It won't run from config.g because it hasn't been homed yet.
You would either have it run once, and then load the saved heightmap (such as with M375) or you would run it before every print. It would depend on your needs. For a delta, proper calibration is critical, and if the bed surface is flat glass, you likely don't need to run G29 at all.
https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer
https://duet3d.dozuki.com/Wiki/Using_mesh_bed_compensation
