Many Thanks dc42…
Updated the firmware to: 1.15e (2016-10-02) ( previously 1.15b)
This sorted the jerky circular movement issue out on my Omerod 2.
On previous boards circles have been perfect. I am currently experiencing slighty jerky printing on circles and am wondering what possible configuration commands I should be looking at to compensate for this.
If anyone can point me in the right direction it would be appreciated.
BTW: If this is the wrong place to post this please let me know for future reference.
Played around again with the config.g and associated files as mentioned. Things seem to be working well now, but I would like to mention to other users if they read this that sometimes it is really important to clear browsing data on the web browser.
Initally to compensate for the 5mm height I edited homeall.g | homex.g | homez.g by uncommenting and changing it to G1 Z-4.2 F6000
This worked well. I then cleared the web browser cache and edited it to the below and now it works and prints perfectly.
I have found that when I make changes sometimes things do not take change until I clear the web browser. I have moved from Safari to Chrome for printing purposes.
I cant stress out for the newbies(of which I am one) that sometimes when you have reconfigured the files and you still get an error report, have a try a clearing the cache (browsing data) first before going psycho. I have spent a week of really late nights trying to sort this.
As a final comment. The duet wifi is a fantastic product and anyone with an Omerod 2 should not be shy moving forward with it.
I have an Omerod 2 (528.3) now with the new Duet Wifi.
Normally in the past,with 0.6 duet or 0.85, I would calibrate the Z probe as per documentation on the RepRap Pro site.
1. Lowered the Z probe down to the bed (enough to catch a piece of paper). This gave me a sensor reading of 966
2.Send G92 Z0 to set for reference
3.Lift up the Z probe incrementally until 600 +/- 20 ( My reading was 606 with a Z probe height of 3mm)
Could someone be as kind enough to guide me to what section of the config.g file (or other file ) that I need to edit. I have tried numerous times editing G31 in the config.g file but the z probe stop at the same position all the time, (which is about 5 mm above the bed) no matter how many times I have edited the config.g file
G31 P606 Z3 .Have tried reconfiguring with the RRF Configuration tool as well with no luck.
This is probably quite an easy fix but I am stuck here in Western Australia trying to work it out and there are not to many crew over here that know what this is all about, it is the last piece in the puzzle.The rest of the duet wifi setup has been exactly as described and it has been a buzz trying to work it all out.