@jay_s_uk Thank you so much for your patience in dealing with my absolute lack of knowledge.

@jay_s_uk that seems to have worked i can get to the web interface now. Thanks so much...
but in order for it to remember the access point is there anything i need to do before unplugging the usb?

@jay_s_uk m552
WiFi module is being started<LF>ok<LF>
m552 s0
ok<LF>
m552 s0
ok<LF>
m552 s-1
WiFi module stopped<LF>ok<LF>
m552 s0
ok<LF>

@dc42
M997 S1
Trying to connect at 230400 baud: success<LF>Erasing 4096 bytes...<LF>Erasing 212992 bytes...<LF>Uploading file...<LF>5% complete<LF>10% complete<LF>15% complete<LF>20% complete<LF>25% complete<LF>30% complete<LF>35% complete<LF>40% complete<LF>45% complete<LF>50% complete<LF>55% complete<LF>60% complete<LF>65% complete<LF>70% complete<LF>75% complete<LF>80% complete<LF>85% complete<LF>90% complete<LF>95% complete<LF>Upload successful<LF>ok<LF>

@dc42 hi im still getting nothing, module wont idle, just returns okay
M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.03 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2019-06-13b2<LF>ok<LF>
M552
WiFi module is disabled<LF>ok<LF>
M552 S0
ok<LF>

Hi I edited the Config.g folder and still cant get the module to idle.

@jay_s_uk will give it a bash, and get back to you.

@dc42 Hi how can i edit the Config.g folder if i cant access the web interface?

@droftarts hi the Firmware -v1.0.7.3. (The Latest as provided by oozenest for WorkBee)
I agree this is probably my issue... problem is i cant get the Module to idle using the M552 S0 , following to the letter your instructions. when you say "use" the Wifi Server Bin. is it just a case of putting it in the SD SYS folder?
if you could explain what to do with the WIFI server bin. file that would be awesome.

thanks for the speedy reply
kind regards

Hi, new to all of this, a bit confused...
The board has been reset via the 2 pin jumper.
I have used bossa to flash the latest firmware. Also put WiFi server bin. On to SD card. Using yat I have tried to set an access point. I was having an error come up saying "another SPI transfer is Pending" after reading several posts on the forum I thought I might need to flash an earlier version of rerap firmware, so did that... Now get the error "unable to set access point"
Another issue maybe related... M552 S0 just returns "OK" and does not put WiFi module in to Idle. I have seriously hit a brick wall, any help you can offer would be greatly appreciated.