I installed my BLTouch, and it seems to be responding to deploy/retraction, test, and reset commands just fine, however it will not stop the Z axis once I tell it to Home Z, or when I send the G30 command to probe the Z offset.

I double-triple checked my wiring and g-code commands, but for the life of me I can't seem to get the machine to respond to the probe, even though the probe responds to the firmware just fine. I made sure that the probe is set to deploy lower than the nozzle, at the recommended distance, but even when I bring the Z axis up, and test the probe by activating it and touching it with my hand, it still reacts, but does not stop.

Any suggestions or ideas would be greatly appreciated.