thx
i will try that
Hi,
I'm currently building a CoreXY printer. but i ran in to some issue's
When i poweron the machine and home the Z the bed needs to go up. but because it takes a while to reach the top when probing slowly to gain the correct accuracy so therefor i want to use a Z-Stop at the low end of the printer. so it knows when its all the way down. and after that raise the bed 60cm and start probing with my piezo the bed for the independed z axis.bed leveling.
especially now while configuring everything i notice the bed leveling is not working as expected.
if its all the way down i have to wait several minutes until it reach the first probing point.
so can i configure a seperate axis with the same motors which start to find the low endstop.
and after that one is triggered configure the z axis to start with a 60cm raise and then start the slow probing.
Johan