@dc42 seems to measure between 0.9 and 1.5 ohms which is I take the lower resistance of 0.9 should work out as 13 amps which is within spec I think.
Never though to measure the resistance of the bed thanks for that
@dc42 seems to measure between 0.9 and 1.5 ohms which is I take the lower resistance of 0.9 should work out as 13 amps which is within spec I think.
Never though to measure the resistance of the bed thanks for that
@Veti @oliof Thanks for the replies, think I will use a SSR just to be safe. Had a spare so not that much of an issue
So a bit odd, i see most heated beds have one positive on negative and thermistor. Wiring would be easy for this. However my cr-10 mini has two positive, two negative and two thermistor cables.
How would I wire the two black and red cables, as normal to the terminals but two per terminal?
I don't want to blow the board by drawing too much power.
Any advice would be great, can't wait to get it up and running.
Bed is stock, 12v 220w, online its called a cr-10 mini MK3 heated bed. Just a bit unsure with this. Was all going so well up until this point
Thanks
Josh