Posts made by jub

Thanks everyone for the swift replies!
Exactly the answers I needed.

I've purchased the Duet3 distribution board and 1lc to go with my 6HC for the RatRig vcore3.
I just saw the following:

Duet 3 with CAN expansion firmware configuration limitations

Duet 3 with CAN expansion firmware configuration limitations
RepRapFirmware (as at version 3.2.2) for Duet 3 with CAN-connected tool or expansion boards currently has the fo...

Due to CAN latency the motors connected to expansion boards may slightly overshoot the position at which the endstop or Z probe was triggered. This would not usually matter for an endstop switch, but it does mean that repeated probing with a Z probe (e.g. for mesh bed compensation) is not advisable. This will be fixed in a future release

How will I use these boards, if I can't use them for mesh bed levelling?
Please advice. Maybe I'm missing something or am misinterpreting the statement.