Sorry, my bad.
I was using M581 and M591.
I was following this thread:
two last posts especially
Everything was set up as described. The only difference is that mine is not working.
Sorry, my bad.
I was using M581 and M591.
I was following this thread:
two last posts especially
Everything was set up as described. The only difference is that mine is not working.
Hi,
lately i'm trying to install SSFS.
When i do it with M582 command, it's working during one print.
I tried it with M592 command, but it's doing absolutely nothing.
What's better, on DWC i can check, that E0 input is reading microswitch correctly ("no" when filament is inserted, "yes" when is absent).
Everything was done as in thread "Inputs for Simple Switch Filament Sensor". After few hours i'm not sure what to do next.
I will be thankful for any help.