Hello Paul,

could you please provide me with the settings for the black widow endstops in the config file ?
I wired mine with the 5V from the panel connector.
Thank you very much

Klaus

Hello everybody,
Has anyone of you a basic setup for a stock black widow run on a duet wifi board. The y-axis works now but I cant replicate it to the x- and the z-axis. I'm looking for good start values for

Set maximum instantaneous speed changes (mm/min)
Set maximum speeds (mm/min)
Set accelerations (mm/s^2)
Set motor currents (mA) and motor idle factor in per cent

Any help would be greatly appreciated.

Thank you very much in advance

Klaus