Hello everyone,
I've a geeetech A30T that is not running as it should with the original motherboard and I bought a duet2 wifi board for it. As the firmware is not open source I was thinking this would be better if I used my own. As I'm new to this I wanted to know how to start this project.
I've 3 extruders on this printer with a 3 to 1 hotend, 3 filament run out sensors, dual Z axis, two optical z switch and standard X and Y stop. for the bed levelling a captive proximity sensor.
I've also a zonestar Z9M3 with same configuration if this project comes to a good end.
This one has also a 3 to 1 hotend, 3 to 2 hotend and a 3 tot 3 hotend.
I've started to read the guidelines but I'm a little bit confused.
Thanks for your help.
Kris