I reflowed the pads on the side of the drive with the SPI pins and everything seems to be working. Thanks.

While setting up a new printer I shorted 2 of the drive pins for E0 doing something stupid while the board had power.
After the incident I noticed that the TMC2660 driver for E0 was extremely hot.
Before buying a new Duet I figured I would try replacing the TMC2660 driver.
With the new driver in place it is no longer hot to the touch but I'm still getting the Short-To-Ground and Overtemp Shutdown error messages every 4 seconds via the web interface. Is there something i'm missing here? Everything else on the board works fine, if it were not for the unending error message I could use E1 and call it a day.