I had a normally closed and stop circuit wired into the connector incorrectly. It was causing fault on the 3.3 V system. Everything seems to be working now, I appreciate everyone who took the time to read this

I had a normally closed and stop circuit wired into the connector incorrectly. It was causing fault on the 3.3 V system. Everything seems to be working now, I appreciate everyone who took the time to read this

I disconnected everything except the 24v in and the USB, and I can connect again, and now my 3.3v green led is on. I will try reconnecting everything one at a time to try and find the problem

Just checked all 3 fuses, and they are all good. Thet have the same voltage on both sides when on.

This issue has been rtesolved.

I’m setting up my first set board. Did I kill it already? I hooked the power from the power supply up backward. Found the problem and fixed it. Now the board lights up but it does not show up on my router and I can’t get it to connect to Yat anymore. Is there anything I can do to salvage the board?

Update Edits:
all 3 fuses are good.

Resolution: I had a normally closed and stop circuit wired into the connector incorrectly. It was causing fault on the 3.3 V system. Everything seems to be working now