@3mm said in Duet Wifi (2.02RC4): AnyCubic Kossel Calibration:

DC42's delta

I have solved it.

Patience and play with the Z offset as well as the offsets in the bed.g file

Just took much longer than i anticipated.

Morning

I recently installed a Duet Wifi (Bought end of 2017) in my Anycubic Linear Plus.

It should be mechanically sound. I changed the steppers to 0.9 degrees and made the estep adjustments, and the X,Y and Z probe offsets have been set (I use a BLTouch)

I cannot do a proper calibration print (a circle). I run the G28 command, and then the G32 command

It probes the bed (without "skipping" an area)

When I start the print, it doesn't appear to do any compensation (even if i have included a G29 command)

The print at the Z tower is squashed

The print at the X tower is squashed

The print at the Y tower has very poor bed adhesion

The end stop screws are the same length. I understand that using the auto calibrate should remove the manual calibration, but I am currently struggling.

If anyone can offer some advice / pointers please?

Thanks

Kenneth