Hi everyone,

I have a large printer set-up that is using a duet 3 with 4 1HCL boards connected via CAN (2 x Y axis, X axis and Z axis).

I have had an issue with the Y axis that if a CAN bus disconnects during a move the disconnected HCL board stops moving, but the still connected Y axis HCL board does not. Should this be the expected behaviour?

I have looked through the forum and looked through the GCode dictionary and have not been able to find any reference to any failsafes in this area.

Any help would be much obliged,
Dan

Thanks phaedrux - I looked there, but completely missed the section I needed - thank you.

Hi All,

Unfortunately I have managed to burn out my power connector for my duet 2 wifi. Its my fault - didnt use ferrules and it eventually caught up with me.

I was wondering if anyone had the specification for the connector so that I can replace it. I cant even seem to figure out the pitch of the connector using farnells and RS components.

Appreciate any help or advice,
Dan