Ha! That was it. Thanks

Hello guys,

My Duet Wifi is working perfectly but I can't get it to connect with my PanelDue 7 (with v2.0 daughter card). I've confirmed that both the PanelDue and Duet Wifi on channel P1 are both set to 57600 and the everything is running the latest firmware (panel is running 1.24). They are connected using a 4 wire ribbon cable and I tested each lead since I don't have a spare cable. I've looked through all the posts and couldn't find anything more to try. Any suggestions?

Thanks!

All good now. Thanks

That work! Thank you.

Does this look in order?

Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 3.01-RC12 (2020-05-06b1)
Web Interface Version: 1.15a

Thanks guys.

I managed to get the board to connect and upload the latest firmware - both Duet2CombinedFirmware.bin and DuetWiFiServer.bin.

Now my only issue is getting the board to accept my camel case SSID & password. I've tried using single quotes before each lower case, creating a macro, and creating a macro with single quotes for lower cases... Any suggestions?

Cheers!

Hello,

I purchased one of the original Duet Wifi V1.02 in mid-2017 (never used) and I finally got around to setting up a new 3d printer this month but the card is now unresponsive. It came up initially and I setup the wifi but then it just died. I've tried fallback methods 1 & 2 (https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware) with no luck. Fallback #3 isn't for my model but I tried pushing the erase button several times and no luck. When I terminal over the serial port on my Mac (at any baud rate), I just get a blank screen and when I try to connect from my Astrobox, it just spins.

I've been waiting for almost 3 years to use this card so any help would be appreciated.

Thank you,
MB